5 golden tips to maintain your car engine
Car manufacturers now provide a longer warranty on their cars than before, which now includes rust, suspension system, chassis, and transmission as well, which has greatly improved the reliability of cars.
Despite this tremendous development in the world of cars, regular maintenance and maintenance of cars is important regardless of the manufacturer or model of the car. Because when you maintain the car, especially when it is new, you will protect it from future breakdowns, prolong its life more and more, and preserve it for many years.
See More : Everything You Need to Know to Car Insurance
1- Measure the engine oil level
When measuring the car’s engine oil level, the car must first be on a horizontal level, and the engine must be run to its normal operating temperature. After that, the engine must be stopped by closing the contact switch and wait about five minutes, then the oil gauge must be removed from its place in the engine and cleaned well with a cloth. A cloth that does not contain lint, then it is placed again in its place in the engine and the oil level is lifted and observed. It must be between the two marks in size and must not be higher than the upper mark or lower than the lower mark. The oil level should not be measured while the engine is running because that will give an incorrect statement of the oil level. By engine.
2- Tire air pressure
When measuring tire air pressure, the tire must be cold, because measuring the pressure after a long drive, the friction between the car’s tire tire and the road increases the heat of the tires and thus increases the temperature of the air inside them, causing its pressure to rise, and then gives an incorrect reading of the pressure value inside the tires.
3- Brake fluid
Not supplying brake fluid (fluid) when the level in the brake fluid tank (reservoir) is low, because the low level of brake fluid indicates the wear of the brake pads and gives the opportunity for the brake indicator lamp to light up in the dashboard. However, when supplying brake fluid, the pads wear out without giving any indication to the driver. Since the brake light did not light. Brake fluid is only supplied when it leaks or when any of the internal parts are changed during the course. It is necessary to strictly prohibit the use of brake fluid because it has a severe effect on the paint of the car’s body, and if it happens to spill on the car’s body, an amount of water must immediately be poured on the place of brake fluid on the car’s body.
See More: Winter Driving Safety
4- Battery cable
When changing or repairing any electrical parts of the car, one must begin by removing the negative battery cable from its place to avoid a short circuit in the car’s electrical circuits. Likewise, when changing the battery, the negative cable must first be removed, then the positive cable. Before removing any of the battery cable, you must first ensure that the ignition switch is in the “contact” position, and that all light switches are closed, so as not to damage the semiconductor parts of the car’s electronic circuits.
5- High engine temperature
When the engine temperature rises suddenly, you must immediately take the right lane of the road and stop the car in a safe place on the side of the road. Immediately close the ignition switch (contact) to stop the engine from running. After that, open the hood (hood) carefully and observe the following. : The presence of any water leakage in the cooling cycle and work to prevent it or repair and change what is necessary. Ensure that the cooling fan is operating properly. After the engine has cooled, the radiator cap can be opened and made sure that there is water inside it. Also, make sure that the radiator water bottle is safe and that there is water inside it to the required level. Ensure the integrity of the radiator cap, ensure the integrity of the radiator itself and that there is nothing blocking the air from it.
